In our daily life, some people may like to listen to songs with headphones. After using the headphones for a long time, we will find that the headphones are easy to yellow, and because the headphones are stuffed in our ears, the dust on the headphones And the bacteria are very much. Even if we use water or dry rags casually, it is very difficult to completely clean the headphones. If there are too many bacteria on the earphone cord, stuffing them into our ears may bring some bad to our ears. Impact, the following small series teaches you three ways to clean the headphone cable, the process is simple and very practical, the effect is not bad.
Method one: toothpaste. In our daily life, everyone may know that toothpaste is only used to clean teeth. In fact, toothpaste plays a big role in our lives. Because toothpaste has a clean and white effect, we can apply some toothpaste on the toothbrush. Rubbing on the earphone wire, so that the yellow dirt on the earphone cord can be completely removed, and then we wipe it slowly with a dry rag, then we find that the earphone cord becomes very white. It can be seen that the use of toothpaste to clean the headphone cable is very good.
Method two: alcohol. In our daily life, when we eat hot pot, we may order some alcohol. In fact, alcohol itself has a disinfecting effect, and the cleaning ability of alcohol is also very strong. Because alcohol is volatile, we can choose soft. A cotton white towel, gently rubbing a little alcohol on the earphone cord, can disinfect the earphones, and can also clean the bacteria on the headphones.
Method three: Eraser. When we went to school, we probably used rubber plaques. The rubber plaques cleaned stubborn dirt very well. We can use some rubber squeegees to continuously rub on the earphone cord. Since the rubber plaque and the earphone cord are all rubber, we are Wipe the dust on the earphone with an eraser, then completely clean the black dirt and dust on the earphone. During the wiping process, we should not touch the earphone wire to the water, so that the water does not enter the earphone, and the earphone is short-circuited due to water. And burned out.